Kent Sundling: Mr. Truck 2-28-11 | TheFencePost.com
YOUR AD HERE »

Kent Sundling: Mr. Truck 2-28-11

Do you carry a wood block or two with you for unhooking your bumper pull trailers so you don’t get tennis elbow cranking down your jack? Progressive Manufacturing, known for their Equalizer weight distributing hitches, have some new trailer products that are genius and simple.

Fastway Flip automatically folds up and down on the bottom of your jack tube. Crank the trailer jack up and Flip folds up when the jack outer tube contacts Flip. Then when cranking the trailer jack down, Flip unfolds and self aligns the jack tube inside Flip. It fits 2-inch and 2-1/4-inch jack tubes, round or square, with 1,400 pound tongue weight capacity. It adds 6-inches to jack when it folds out … no more blocks. Install is so easy, just drill one bolt hole through the jack tube (Flip has a template built in for drilling). Just set Flip on its back on a block, flat and level, then drill through the guide holes in the flip on each side. Add the large washer and attach Flip to the jack tube with one bolt. It only takes about 30 minutes to install, so slick. It comes with all the hardware and a self locking nut, just don’t over tighten.

Do you carry a wood block or two with you for unhooking your bumper pull trailers so you don’t get tennis elbow cranking down your jack? Progressive Manufacturing, known for their Equalizer weight distributing hitches, have some new trailer products that are genius and simple.

Fastway Flip automatically folds up and down on the bottom of your jack tube. Crank the trailer jack up and Flip folds up when the jack outer tube contacts Flip. Then when cranking the trailer jack down, Flip unfolds and self aligns the jack tube inside Flip. It fits 2-inch and 2-1/4-inch jack tubes, round or square, with 1,400 pound tongue weight capacity. It adds 6-inches to jack when it folds out … no more blocks. Install is so easy, just drill one bolt hole through the jack tube (Flip has a template built in for drilling). Just set Flip on its back on a block, flat and level, then drill through the guide holes in the flip on each side. Add the large washer and attach Flip to the jack tube with one bolt. It only takes about 30 minutes to install, so slick. It comes with all the hardware and a self locking nut, just don’t over tighten.


Start a dialogue, stay on topic and be civil.
If you don't follow the rules, your comment may be deleted.

User Legend: iconModerator iconTrusted User